Hydrostar Test Results

Created "Oct 8 2004"


Note to all: There is One Error on my board. A .1 cap from the
555 pins 6&7 to ground.
I fixed it on my proto, but the board here isn't corrected.
***************************************************************

In My opinion, that circuit is Crap and does not work. 

I don't know who designed it, but there are definate faults. 

Here are a Few of Many:

1) The use of a 741 op-amp to generate a 1 to 4 volt signal is 
   stupid and doesn't work. 

2) Pin 5 of the 555 is a Voltage Control Pin. The Normal 
   voltage on this pin is around 7 volts with a 12 volt supply. 
   All that is necessary is to use a pot to pull the voltage down. 

3) The 4069 circuit uses very low resistor values. not normal 
   and results in excessive currents. 

4) The divide by 1000 circuit is stupid. Yes that works, But a 
   simple 555 set for a 15 to 20 Hz osc would give the same results. 

5) The Fact that he doesn't give a Schematic for the dvide by 
   1000 circuit (4059), I don't believe he ever built this. 

6) The use of the TC4420CPA is Also Stupid. A 555 can drive 
   200 mA. Thats enough power to drive 10,000 Mos Fets as they 
   are a voltage operated device. 

7) the Pots from pin 6&7 of the 555's should Never be adjusted
   to Minimum, It can Distroy the 555's. Another Fault. (I Knew 
   this and added a Limiting Resistor in Series, on the proto board) 

8) the use of a 10k resistor to the base of the 2N3055 is way 
   too high. This is a Power Transistor and Require Current 
   Drive. This Resistor Limits Current Severely. 

9) And his test procedure write-ups on pages 75, 76, 77 is rediculuous. 
   Every Time "he says if it doesn't work, there is a Faulty Part". 
   Other than the One Error I made on the board, which I fixed, 
   IT IS TOTALLY CORRECT to his Schematic, All New and GOOD 
   Parts, but does Not Work as stated. 

Sorry But my opinion: This Whole Design is Faulty. I SERIOUSLY 
Doubt anyone has this Actual Circuit Working. 

My Suggestion to anyone wanting to do Hydrogen Generation,
is to just build my PWM Circuit or something simular.


 

All Imformation in this Article is "Copyright protected".

Chemelec

*Copyright © 2004*