Instructions to clean an Enviro gas 828 fireplace. Welcome to Shebang, your free information site.
Clean a free standing Gas fireplace
Cleaning Instructions
Enviro 828 control panel.
Pull forward the tray in front of the controls to reveal the control panel.
Turn the control knob to the off position, the gas is shut off.
Open the two side panels, they are held by magnets at the bottom of each panel.
Only a pull is required to open the side doors.
There is one holding bolt on the right side holding the swinging front glass window panel of the unit.
The picture shows the 1/2 inch open end wrench in place. Lift the wrench upward
to unscrew, once the bolt is loosened, unscrew with finger pressure.
Front panel swung open, shows imitation logs in place.
Wipe the glass with a damp cloth, there is only a light white powder to remove.
Lift the imitation logs out of the fireplace and place on cardboard or cloth,
No cleaning is required. There are three parts
Inside view of Enviro gas 828 gas fireplace.
Vacuum the inside of the fireplace touch up with a damp cloth
to remove any white powder.
Place the longer imitation log back into the unit, there are two studs on the front for placement,
the placement studs drop into holes to keep it in place. The two smaller logs are placed on top of the longer log, using the guide studs for placement.
Swing the front door shut and secure with the holding bolt on the right hand side of the unit. Tightened the holding bolt by hand while the door
is pushed closed, tighten the bolt finger tight, then use the wrench
tighten one half turn more. Close the two side panels held shut by the magnets.
Vacuum the back underside of the unit.
On the control panel turn the control knob to pilot, press the knob in and press
the spark knob several times to light the pilot flame.
Once lit, the knob is held in the pressed position for one minute. The knob is released and turned to a setting. If the pilot flame will not light with the spark device, wait five minutes to let any gas disperse, then hold the pilot knob in, and light the pilot flame, with a match.
Feel free to click the +1 button if you found this helpful.
