Step-By-Step Instructions On the Creation:

1. Finding the OTF V2 Station Graphic that was a normal page size without distortion.

2. Remove the background, leaving just the station.

3. Creating a 8 x 10 inches sheet to work on.

4. Taking the station and pasting it on the page.

5. Turn the picture into grayscale.

6. Use the Contrast and Brightness option to remove any shadows and make it look flat.

7. Print. (Here is the Template)

8. Find a Pumpkin in which to use. (Find one with a smooth front, make sure you wash it aswell).

9. Clean out the inside of the pumpkin.

10. Place your pattern on the pumpkin. (Using 2 - 4 Tac's to Hold it in place)

11. Use a tac to poke your design into the pumpkin, by poking around it. (As you go you may need to temporarily tac it down and use another tac to continue around.

12. Once complete, remove the design/pattern from the pumpkin. You should see your design poked into it. (If you can't see it that well enough to cut, use some good ole all purpose flour and rub it in, this will make it stand out.

13. Get out your carving tools and cut away, making sure you review where your going to cut first. (With the template, cut out the white area).

14. Congratulations, you've got yourself a Outpost10F Station Pumpkin.

15. Light a small tea-light candle and let it glow.