Just a note of protocol: Do not go upstairs and turn on the mikes, etc. unless you are invited to do so, you don't want to interfere with someone else's settings.
To turn it on, first turn on the Furman power bar, then the AMP power under the red cover. First on last off. So when you turn it off, do it the other way.
http://www.soundcraft.com/pdf/brochures/guide_to_mixing_brochure.pdf
http://www.soundcraft.com/pdf/brochures/guide_to%20_digitial_mixing_brochure.pdf
On this board the solo switch is the “PFL”(Pre fader listen) and is Pre-fader. (Opposite to Mackie) So you don't need the fader up and mike ON to adjust the trim/gain.
The Sub groups (Only 4) are stereo.
The OFF/ON switch actually lights green when it is ON.
With this board, if something goes wrong with a particular channel, it can be removed separately and repaired, whereas with the Mackie, you have to send out the whole board.
Mackie Upstairs Extension Board
Channel 23/24 is the CD Fader.
Channel 22 is the fader that controls the feed from MIX B downstairs for the Video.
Site Created by: Media Creations 2000
Copyright ©
1998-2003 by [R.J. Fisher]. All rights reserved.