Pattern - Bias Garter Stitch Scarf

The pattern begins at one corner and increases on both ends of the knitting until the width is achieved. This makes a triangular piece. Knitting then continues by increasing on one edge only (hint: mark this edge with a loop of scrap yarn), while decreasing on the other edge until the length is achieved. The finishing triangular section is made by continuing the knitting and decreasing at both edges until only one stitch is left.

Abbreviations:

S1 - yarn forward, slip purlwise, yarn back (done on first stitch of every row throughout)

Inc - knit into the front then knit into the back of the same stitch before dropping it from left needle

Dec - slip 1, knit 1, pass slip st over

Beginning Triangle:

Make a slip knot and K, P, K into it. (3 sts total)

Row 1: S1, KPK into next st, K1. (5 sts total)

Row 2: S1, Inc, K to end of row.

Repeat Row 2 until you have 28 sts on needle. Then continue with--

Long Section:

Row 1: S1, Dec, K to end of row.

Row 2: S1, Inc, K to end of row.

Repeat rows 1 and 2 until long edge, slightly stretched, measures 142 to 145 cm (56" to 57"). Then continue with-

Ending Triangle:

Row 1: S1, Dec, K to end of row.

Repeat row 1 until 3 sts remain on needle.

S1, K 2tog, PSSO.

Cut end and draw through last stitch. Darn in ends and block.

Wash and block following the instructions on the patterns page.

Check out the Bias Fisherman's Rib pattern as well.